ATIG-PACIII series is fully digital models with high end DSP technology, it is suitable for both automatic application and manual welding. Compared with ATIG-PAC series, it offers advanced wave control technology which brings more flexibility for thinner /thicker material during critical aluminum welding. Smart parameters adjuestment brings cleanest, deepest penetration and perfect welding result for high welding quality demanding.
Output
Input
Process
Share:
Multi-core MCU + DSP control
Multi-process: AC TIG/AC PULSE TIG/DC TIG/DC PULSE TIG/MMA
HF TIG and LIFT TIG
Five kinds of AC waveform output, AC TIG aluminum welding expert
TIG parameters are adjustable (pre-gas/post-gas, up-slope/down-slope, arc starting/stopping, peak/base current, duty cycle/ frequency, AC current/ clean ratio/ AC frequency); digital display
2-T, 4-T, repeat and spot welding operation mode
One-key to save and recall 30 sets of parameters
Synchronous mutual welding function can be carried out by two welding machines
Water-cooled and gas-cooled TIG welding torches are applicable
Remote control function: wired remote control [analog type and digital type can be applied], foot pedal, potentiometer type welding torch whose current is adjustable
Continuously adjustable hot arc starting current, hot arc starting time, arc force and knee-point voltage in MMA mode realize effects of unbroken arc, anti stick and stable arc
Suitable for BAS & RUT welding
Full-bridge inverter soft switch control technology, double primary inverter IGBT modules, secondary inverter module, quick recovery diode module;
PCB is processed with three-proofing lacquer; the drive board is processed with rubber for protection
It enjoys IP21S class protection and H class insulation
Protection against overheat, over-current, over-voltage and lack of coolant; protection against welding torch switch short-circuiting; error code display
ONLINE MESSAGE
RELATED PRODUCTS